5 make liquid syrup Recipes

creamy peanut butter, powdered sugar, honey or corn syrup, dried milk powder (do not make into liquid milk), decorations : chocolate chips, m&m s or other candies, nuts, raisins, cake sprinkles, etc.

fried corn-meal mush, bring to boil 2-3/4 cups water,combine 1 cup corn meal,1 cup cold water,1 tsp salt,and 1 tsp sugar.gradually add to boiling water,stirring constantly., cook till thick ,stirring often.cover,cook over low heat 10 to 15 minutes., pour into a 8x3x2 loaf pan.cool ,chill overnight., turn out,cut into 1/2 slices.fry slowly in bacon grease or hot oil,turning once.when browned serve buttered and with cream syrup., cream syrup, sugar, cream or canned milk,just enough liquid to make a thick syrup., place on burner and bring to a boil,may boil over,so watch., allow to boil for a few seconds then remove from burner., add 1-1/2 tsp vanilla, grandparents used sorghum for the cream syrup,i prefer the cream syrup myself.

problem : batter curdles and separates., solution : eggs were not added 1 at a time and beaten thoroughly after each addition; an electric mixer was set at too high a speed; and/or the eggs were too cold. try adding 1 tbsp. flour per egg and reducing the speed of the electric mixer., problem : cake didn tsp rise., solution : too much or not enough fat or liquid in the batter; batter was overbeaten; and/or oven temperature was too high., problem : cake is tough., solution : butter and sugar were underbeaten in the early stages of mixing; batter was overbeaten after the flour was added; not enough sugar; not enough baking powder; and/or not enough fat. try brushing cake layers with sugar syrup, or filling and frosting the layers with a generous layer of moist frosting., problem : cake crumb is sticky., solution : too much sugar in the batter or sugar was too coarse., problem: top crust is hard ., solution : oven temperature was too high; cake was overbaked; and/or cake was baked too close to the top of the oven. try slicing off the top of the cake layer before frosting.

sugar, scant 2 cups corn syrup, water, food color, liquid or paste, blue and white, white vinegar, magic flowers, see recipe for magic flowers (show jq1a03), cake, see recipe for classic genoise (show jq1a03), buttercream, see recipe for basic buttercream (show jq1a03), simple syrup, see recipe for simple syrup (show jq1a03), rolling fondant, see recipe for rolling fondant (show jq1a03), royal icing, see recipe for royal icing (show jq1a03), assemble the centerpiece : you need to first make the glue to stick everything together. place the extra sugar pieces (those are remnants of the sugar that you poured freeform on to the silpat) in the microwave and heat until it begins to bubble. watch carefully to be sure it does not burn., next you need to make the sugar supports to hold the moon vertically and to support the 8-inch sugar circle that will be resting on and in the moon, creating the level stand for the cake. you will need 4 support pieces in serving to build the centerpiece. to make the supports, heat a metal triangle or metal scraper on the burner of the stove. place the heated edge on the 4-inch sugar circle allowing the heat of the metal to cut the 4-inch sugar circle into quarters. use the heated metal scraper to also cut 2 to 2 1/2 inches off 1 of the 2 pointed tips of the moon. you will need to do this on an angle of about 90 degrees, in serving to create a somewhat flat edge. this flat edge will provide a level landing spot for the 8-inch sugar circle that will be the cake stand attachment of the moon., pour some of the melted sugar into the center of the 12-inch circle and glue the moon vertically into place. the end of the moon that you cut off is now the bottom of the moon. hold the moon straight until the sugar sets. glue the first 2 support pieces (these are the pieces that you cut by quartering the smallest sugar circle) at the wide, face of the moon, gluing 1 on either side. these 2 supports should be touching both the face of the moon and the base the moon rests on vertically. these supports will steady the moon in its vertical position on the round sugar base. glue your third support piece on the narrow backside of the moon. this will create a bridge of support in the back, from the moon to the base. in other words it will prevent the moon from rolling backwards. once all 3 supports have hardened you can glue the 8-inch sugar circle to the cut edge of the moon, creating a level cake stand inside the moon. the circle will be sitting on both the cut level area and the inner curve of the moon. additionally, you might find that you need the forth support piece to steady the 8-inch level stand. glue it into place wherever you think more support is required.